General glass cutting method with special glass cutter at the lowest cost in case fine dimensions are not required.
- Glass cutter is not a tool to cut the glass, but to make a scratch on the glass.
- You should use a rubber ruler when you use the glass cutter.
- You can make a scratch on the glass by withdrawing the glass cutter on the glass.
- You can cut the glass at the line by hands.
- As cutting plane is dangerous, there is a chamfer treatment available.
- In case of cutting a few glasses, this is the most inexpensive way to cut the glass.
Precise cutting method with high speed rotating diamond wheel.
- We can cut the cylindrical glass by rotating whetstone at high speed.
- We can cut glass pipe or rod from small to large diameters.
- There may be fine chips on the cutting plane, there is a chamfer treatment available.
- We can grind the glass surface to be in the tolerance.
- We can polish the glass surface if the transparent surface is required.
Precise cutting method to cut along curved lines freely with diamond tool.
High Speed Precision Cutter
Cutting method to cut glass plate with GC cutting whetstone.
- By moving a table where the glass plate is put on, the glass can be cut with whetstone.
- Cutting plane is quite fine.
- Precise cutting can be done.
- Several glass plates can be cut at a time.
- Max. 100mm sq. glass plate can be cut.
- This can be used for not oily cutting, but grooving.
Products by using cutting technique